Caterpillar 14M3 Motor Grader
Specifications
Engine
Number Of Cylinders
6
Torque Rise
41%
Displacement
763cu in
Bore
5.1in
Stroke
6.2in
Emissions
Tier 4 Final/Stage IV, Tier 3/Stage IIIA equivalent or Tier 2/Stage II equivalent
Engine Model
Cat C13 ACERT VHP
Note (1)
Net power is tested per ISO 9249, SAE J1349, and EEC 80/1269 Standards in effect at the time of manufacture.
Note (2)
Optimized VHP Plus is standard for the 14M3.
Note (3)
Net power advertised is the power available at rated speed of 1,850 rpm, measured at the flywheel when engine is equipped with fan, air cleaner, muffler and alternator.
Note (4)
Power as declared per ISO 14396 Rated rpm 1,850 VHP+ = 228 kW (306 hp)
Note (5)
Cat engines equipped with a Selective Catalytic Reduction (SCR) system are required to use: Diesel Exhaust Fluid (DEF) which meets the requirements outlined in the International Organization for Standardization (ISO) standard 22241-1.
Base Power (1st Gear) - Net
238hp
Standard Capability
122degrees
Speed At Rated Power
1,850 rpm
Maximum Altitude - Full Power (Tier 2)
12049ft in
Maximum Torque - Vhp Plus
1137lb ft
Frame
Front Axle - Total Oscillation Per Side
32 degrees
Front Axle - Wheel Lean - Left/Right
17.1 degrees
Engine
Standard - Fan Speed - Maximum
1,600 rpm
Standard - Fan Speed - Minimum
550 rpm
Maximum Altitude - Full Power
13900ft in
Maximum Altitude - Full Power (Tier 3)
14349ft in
Frame
Circle - Outer Diameter
71.7in
Weights
Note
*Base operating weight calculated on standard machine configuration with 20.5 R25 tires, full fuel tank operator and ROPS cab.
Gross Vehicle Weight - Typically Equipped - Rear Axle
42005lb
Gross Vehicle Weight - Typically Equipped - Front Axle
15245lb
Gross Vehicle Weight - Typically Equipped - Total
57250lb
Operating Weight - Typically Equipped
57250lb
Gross Vehicle Weight - Base* - Total
50980lb
Gross Vehicle Weight - Base* - Front Axle
13994lb
Gross Vehicle Weight - Base* - Rear Axle
36994lb
Moldboard
Blade Width
14ft in
Arc Radius
16.3in
Throat Clearance
4.6in
Blade Width - With End Bits
169in
Blade Width - Without End Bits
164in
Blade Height - With Cutting Edge
24.9in
Blade Height - Without Cutting Edge
23in
Air Conditioning System
Air Conditioning
The air conditioning system on this machine contains the fluorinated greenhouse gas refrigerant R134a (Global Warming Potential = 1430). The system contains 2.0 kg (4.4 lb) of refrigerant which has a CO2 equivalent of 2.860 metric tonne (2.76 ton).
Blade Range
Circle Centershift - Right
20.5in
Circle Centershift - Left
25.6in
Moldboard Sideshift - Right
31.1in
Moldboard Sideshift - Left
29.1in
Blade Tip Range - Forward
40 degrees
Blade Tip Range - Backward
5 degrees
Maximum Shoulder Reach Outside Of Tires - Right
78.9in
Maximum Shoulder Reach Outside Of Tires - Left
73.6in
Maximum Lift Above Ground
16.5in
Maximum Depth Of Cut
23.3in
